colors care backup

Fabric Care

Required Items:

  • Chemical sprayer
  • Garden hose
  • Garden hose nozzle
  • Brush or sponge for scrubbing awning
  • Vinyl or fabric cleaner
  • Vinyl or fabric sealer
  • Ladder
  • Extension poles

Applying Cleaners

Use cleaners that are specifically formulated for vinyl or fabric materials.

  • Apply cleaner to a dry awning. Wetting the awning often reduces the effectiveness of the cleaners.
  • Apply cleaner evenly and with a saturating mist. Apply from the bottom up. Do not let cleaner dry on the awning.

Scrubbing the Awning


  • Vinyl Awnings: Hand scrubbing with a soft sponge is the best way to clean a moderately soiled awning, although a soft- bristle brush is also safe and effective. Never use abrasive cleaners or scrubbers.
  • Fabric Awnings: A soft or medium brush, or similar scrubbing device, works best.


  • Wash in a consistent fashion with even and usually up and down strokes.
  • Apply uniform pressure when scrubbing.
  • Start from bottom and work up.
  • Overlap your strokes. This will guarantee that no sections are missed.
  • Apply cleaners to all underside surfaces and let stand for 5 to 15 minutes, then rinse thoroughly. Usually, scrubbing of the awning interior is not required.

Note: If awning is still not clean, repeat the above process.


Garden hose or pressure washer. Pressure should not exceed 300 PSI.
Thoroughly rinse the awning until the water runoff is clear. Residual cleaner may leave a chalky appearance on the awning after it dries.

Special Tips

Pressure cleaning is a common cause of permanent awning damage, and it is very ineffective. A pressure washer can be used as a water delivery system for rinsing your awning after cleaning or for removing debris (cobwebs, bugs, leaves, etc.) from the inside of the awning. Pressure should not exceed 300 PSI.
If limited mildew exists, then a chloride-free “mildew cleaner” can be used. If mildew is severe, than diluted liquid chlorine is necessary. ALWAYS do a Q-tip test in a hidden spot to make sure the material is colorfast.
When using chlorine:

  • Use it as diluted as possible without taking away from effectiveness.
  • Use only where necessary.
  • Do not let it dry on the awning.
  • Thoroughly rinse so that chlorine is completely flushed from awning. If there are plants nearby, they should be sprayed in advance of treatment to prevent burning of plant leaves and roots.

Fabric Awning Sealing Instructions

Required Items:

  • 2-pint or 1-gallon pump sprayer
  • Ladder

Vinyl Material

The Product:
Vinyl sealers are typically water-based silicone products and will last from two to four months.
The best way to apply the sealer is with a small pump sprayer. Lightly mist the product on the awning and rub with a sponge or clean terry cloth towel.
The sealer is a barrier between the elements and the environment. They offer UV protection, slow the growth of mildew and leave the material supple and shiny. Another benefit is that they make future cleaning easier.

Fabric Material

The Product:
Fabric sealers can be water- or solvent-based products. The water-based products last six months, are easy to work with and easy to clean up. The solvent-based sealers offer the longest protections.
The sealer is a barrier between the elements and the environment. They offer UV protection, waterproofing, slow the growth of mildew and make future cleanings easier.

Special Tips

Awning Interior:
It is usually not necessary to seal the bottom side of a fabric awning. If you are trying to waterproof a patio awning, then sealing both sides can be very helpful.